| Author |
Message |
    
Ben Tuppen
Member
Username: bentuppen
Post Number: 14
Registered: 07-2005
| | Posted on Tuesday, August 22, 2006 - 05:20 pm: | 
|
Hiya. A quick one here. i've lost one of the nuts for my stuart sea cock water inlet (original fit for my boat's r3m: the standard one I've seen on a few boats, with three bolts through the bilge, and a small lever, with the option to use the engine to pump out the bigle). I'm just not quite sure what I'm after if I go to get a replacement from a shop - 'brass nut which fits a 7/16 spanner' is about as far as I've got.
Thanks!
Ben |
Tim Mulvey
Senior Member
Username: timmulvey
Post Number: 95
Registered: 05-2003
| | Posted on Wednesday, August 23, 2006 - 04:58 am: |
|
I have the Stuart seacock that you have mentioned, so I can measure the thread if that helps or if you are in Australia could arrange for it to be fabricated (without the wings on top) - if you are overseas I presume it would be expensive to post but can give you dimensions. Email me to discuss |
Peter Ogborne
Senior Member
Username: peterogborne
Post Number: 166
Registered: 09-2002
| | Posted on Wednesday, August 23, 2006 - 06:14 am: |
|
Ben ....you need a 1/4 BSF brass nut |
Ben Tuppen
Member
Username: bentuppen
Post Number: 15
Registered: 07-2005
| | Posted on Thursday, August 24, 2006 - 02:19 am: |
|
brilliant. thanks guys. I'll see what I can find. (very excited as the boat is in the water as of last night taking up. I'll be fitting the engine tomorrow!) |
