|
| Stuart Turner....sprocket size |
| Author |
Message |
    
peterogborne
Senior Member
Username: peterogborne
Post Number: 251
Registered: 09-2002
| | Posted on Sunday, May 22, 2005 - 07:58 pm: | 
|
Some time back someone was asking the sprocket size on a magneto for a S/T engine . Did they get an answer if not get in touch with me and i will post it. |
dondom
Member
Username: dondom
Post Number: 7
Registered: 03-2005
| | Posted on Monday, May 23, 2005 - 03:19 pm: |
|
i was asking the sproket size to go on a wico series a for a p55 industrial ok i have 17 tooth sproket on there now same size and pitch as the one on the engine i have had the engine running but backfiring quite badly so i think i require some help on setting up points etc you have now gathered i am a coplete novice with this engine
but i got it in three big bits and a box odds and ends and only with help from the more informed have i got this far and would like to see the engine running again. thanks TOM |
peterogborne
Senior Member
Username: peterogborne
Post Number: 252
Registered: 09-2002
| | Posted on Monday, May 23, 2005 - 06:01 pm: |
|
Tom , sounds like you are heading in the right direction , backfiring could be because your fuel mixtre is too lean . |
|
|
|
|
