|
| Palmer 7300 Exhaust Manifold |
| Author |
Message |
    
Lans Bouthillier
| | Posted on Saturday, August 10, 2002 - 03:51 pm: | 
|
I�m looking for an 7300 exhaust manifold w/riser for a Palmer Model M265, 150 HP, 3600 rpm gas marine engine. Prefer one used in fresh water. Must have been pressure tested and be in working order. Any info or leads rae appreciated. |
andrew
| | Posted on Saturday, August 10, 2002 - 09:35 pm: |
|
Lans,
You should post a wanted ad in our classifieds section.
I am afraid it is going to be hard to find that manifold. You should also look for a complete engine with the hope that you can find a good manifold on it and keep the rest of the engine as a spare. I don't know of any aftermarket suppliers for it.
The Palmer M-265 was based on the International Harvester IH-264 block... but of course IH never had a marine manifold.
There are some companies that specialize in custom fabricated manifolds... but they are expensive.
Regards,
Andrew |
Peter Metcalf
| | Posted on Sunday, August 18, 2002 - 04:55 pm: |
|
Lans,As youay or may not have noticed in the classifieds, I am also looking for an M-265 manifold. Best of luck to you, and if I find two, I'll let you know. Some derelict twin screw cruiser on the Great Lakes would help us both out. |
Charlie Baker
Visitor
| | Posted on Friday, September 17, 2004 - 09:22 pm: |
|
I am looking for an exhaust manifold for a Palmer International392 boat motor. Can anyone suggest where to locate one?? |
|
|
|
|
