| Author |
Message |
    
kevin stone
Advanced Member
Username: kdstone
Post Number: 39
Registered: 01-2009
| | Posted on Sunday, June 19, 2011 - 01:11 pm: | 
|
I posted this question twice to get it on top ;)
Hello everyone, I have 2 Sherwood e20 water pumps I want to rebuild. All of the rebuild kits I find have no shaft. Has anyone had any luck finding replacement shafts? We just about to pull and rebuild the Palmer and would like to rebuild the leaky pumps also.
Thanks
Kevin Stone
[email protected] |
steven john page
Senior Member
Username: fairbanks
Post Number: 54
Registered: 12-2007
| | Posted on Sunday, June 19, 2011 - 07:09 pm: |
|
hi Kevin,do you have any photos of the E20 pump as i have a sherwood with shaft surplus to requirement it has been nocking around my workshop for a few years now looking for a new owner, regards steve. |
kevin stone
Advanced Member
Username: kdstone
Post Number: 40
Registered: 01-2009
| | Posted on Sunday, June 19, 2011 - 08:54 pm: |
|
Steven, I sent 2 photos to your listed email address |
steven john page
Senior Member
Username: fairbanks
Post Number: 55
Registered: 12-2007
| | Posted on Monday, June 20, 2011 - 08:08 am: |
|
Hello Kevin, am sorry to say that the pump i have is made of bronze and doesnt look like the one in your photo so i assume that it is from an older engine . hope you are successful in your search. regards steve. |
Curt Larsen
Member
Username: curtlarsen
Post Number: 7
Registered: 05-2006
| | Posted on Tuesday, June 21, 2011 - 07:54 am: |
|
I had an E20 rebuilt for me about 3 years ago (not the pump I have up for sale right now)and got the replacement shaft from Marysville Marine. The phone number I have for them is 1-800-367-0987. This pump was also rebuilt for me by Bruce Gay at Long Beach Boat Co. |
