|
| Author |
Message |
    
codraro
Member
Username: codraro
Post Number: 12
Registered: 06-2011
| | Posted on Sunday, June 12, 2016 - 06:12 am: | 
|
After rebuild Hercules IXB found two head studs would not hold torque due to fine threads bad
Should I remove and replace one stud at a time and can I replace only the two |
jb_castagnos
Senior Member
Username: jb_castagnos
Post Number: 1171
Registered: 07-2002
| | Posted on Sunday, June 12, 2016 - 12:21 pm: |
|
Changing studs shouldn't be a problem if you can remove them. Were they recently out, that would make it easier. I think the SAE fine is on the nut. I would replace all nuts with grade 8, double check your torque specs. |
|
|
|
|
