|
| Author |
Message |
    
mcinton
New member
Username: mcinton
Post Number: 3
Registered: 08-2010
| | Posted on Saturday, September 10, 2011 - 08:34 am: | 
|
I need to replace my bushings in the crankcase of my Dispro engine. What material is used?
Brass or bronze? Or is there a special brass I must use.
Any help as always would be appreciated.
Thanks |
johnoxley
Advanced Member
Username: johnoxley
Post Number: 33
Registered: 04-2010
| | Posted on Sunday, September 11, 2011 - 10:04 pm: |
|
Hi - even though they were once called "brasses" you must use a bronze - try standard bushes first, then hollow bronze stock usually LG2 should be OK. See http://www.pacificbronze.com.au/lg2_spec.pdf but do not know which country you are in. |
bcm
Member
Username: bcm
Post Number: 27
Registered: 11-2009
| | Posted on Monday, September 12, 2011 - 09:32 am: |
|
Norm,
Suggest alloy 660 cast bronze cored bar available in 13" lengths from Canadian Bearings, 48 Pacific Ave, Sudbury, 705 673 2047
Sizes as attached
Barry
 |
|
|
|
|
