| Author |
Message |
    
Ben Sidaway
Visitor
| | Posted on Friday, November 05, 2004 - 11:50 am: | 
|
I have a 1970 Palmer M-60 and attempting a rebuild. I need to find a head gasket. The original one was chewed badly trying to get the head off. It was a sandwich of copper and fibre. Any help in locating a replacement would be appreciated |
C. Bolin
Visitor
| | Posted on Wednesday, November 24, 2004 - 02:09 am: |
|
Fel-Pro makes a gasket for the International Harvestor Cub 60 tractor, same engine as Palmer P-60 |
eddie
Advanced Member
Username: eddie
Post Number: 33
Registered: 04-2003
| | Posted on Wednesday, November 24, 2004 - 07:45 am: |
|
The C-60 tractor head gasket is easy to get and is a perfect fit. There is some question wether it will hold up to a marine enviorment being that it is not copper.
Eddie |
richardday
Senior Member
Username: richardday
Post Number: 330
Registered: 11-2003
| | Posted on Wednesday, November 24, 2004 - 08:53 pm: |
|
In my opinion get a copper one made as the tractor gasket won't handle salt hot water long and then you have a real mess. There are posts that will lead one to a source of makers of replacement gaskets. Look Under Palmer P-60 etc. |
Ben Sidaway
Visitor
| | Posted on Monday, November 29, 2004 - 10:57 pm: |
|
Richard, could you point me to a manufacturer of a copper head gasket for my M60. I haven't been able to find a source in previous posts except for Molina's in CA and I haven't been able to get a hold of them yet. |
richardday
Senior Member
Username: richardday
Post Number: 332
Registered: 11-2003
| | Posted on Tuesday, November 30, 2004 - 10:55 am: |
|
http://www.safetyvalve.com/ These people make copper head gaskets. They are located in Baltimore and Norfolk. Try them |
