|
| Author |
Message |
    
Paul R.
| | Posted on Thursday, August 22, 2002 - 06:10 pm: | 
|
I have just purchased a Flathead Ford Marine Engine, it has factory 21 stud aluminum heads. The transmission has foward, reverse and neutral. The water pumps are different than any other fltahead that I have ever seen. Does anyone know anything about this type of engine.
Thanks,
Paul |
andrew
| | Posted on Thursday, August 22, 2002 - 06:34 pm: |
|
Paul,
Is there any indication what company did the "marine coversion" of the engine? A namplate or a name cast into the manifold for instance?
Regards,
Andrew |
A. K. Timer
| | Posted on Monday, September 08, 2003 - 06:12 pm: |
|
Is it by any chance a Ford Flagship engine - a flathead 6? If so, there should be a nameplate on the top of the transmission at the 'rear' of the engine. I have a manual. |
Craig
| | Posted on Wednesday, June 16, 2004 - 04:27 pm: |
|
Does anyone know where I can get the necessary parts (transmission, manifolds, oilpan etc.) to convert a Ford flathead V8 to marine use? |
andrew
| | Posted on Wednesday, June 16, 2004 - 05:13 pm: |
|
You will need a lot...
Try Osco |
Eric
| | Posted on Tuesday, June 22, 2004 - 01:09 pm: |
|
I have a complete v-8 flat head ford engine with water jackets and transmission for sale. call for details 519-638-5457 |
hotrodder
Visitor
| | Posted on Monday, August 02, 2004 - 06:24 pm: |
|
your flathead is a 32/37 engine |
slapshot2
New member
Username: slapshot2
Post Number: 2
Registered: 11-2006
| | Posted on Thursday, December 07, 2006 - 11:36 am: |
|
I have a flathead ford v8 engine that was setup for marine use. There are alot of special parts that go with the engine, intake manifold is tilted to allow for it to be vertical. Marine waterpumps, impossible to find replacements with fubber impellers, exhaust manifolds that are water cooled. I am building a hotrod marine engine |
David N. Aker
Visitor
| | Posted on Wednesday, November 25, 2009 - 01:35 am: |
|
i am also looking for info on a flathead six marine engine. It is a model 90 with serial number1925. On the head it says Flagship Marine, and on the block it says FEANO with the numbers 2GA6015--5. I have the engine, transmision and prop shaft.
Please contact me at [email protected] with any info. |
drrot
Advanced Member
Username: drrot
Post Number: 45
Registered: 09-2008
| | Posted on Wednesday, November 25, 2009 - 07:54 am: |
|
David,
Can you post a photo? Some Flagship engines were converted Hercules. |
derus
Visitor
| | Posted on Wednesday, February 17, 2010 - 10:39 am: |
|
I have a Gray Marine Phantom Six 125 which I believe is the Continental F-244 a 244cu in 6 with a (and here is where I am unsure) a integral type of exh and intake manifold with two 63 series carbs.(Zenith) I need a manifold and carbs with flame arrestors. Wondering what availibility and cost are for them. Would appreciate any info. Thanx much, Derus |
|
|
|
|
