|
| Author |
Message |
    
David Woodworth
Advanced Member
Username: david_woodworth
Post Number: 32
Registered: 05-2012
| | Posted on Monday, January 10, 2022 - 09:57 pm: | 
|
Can anybody help with the kind of oil seal I should use in the Detroit gear? |
Ernie
Senior Member
Username: ernie
Post Number: 2669
Registered: 01-2002
| | Posted on Tuesday, January 11, 2022 - 08:02 am: |
|
David,
Just measure the ID of the bore where the seal goes and the OD of the shaft.
Then go to your local bearing/seal supplier and they should be able to provide them for you.
No bearing/seal supplier then use the link below with yor dimensions. Make sure to click the search by dimensions tab at the top.
Hope this helps
Ernie
https://www.skfextranet.com/crsealsfinder/ |
Ernie
Senior Member
Username: ernie
Post Number: 2671
Registered: 01-2002
| | Posted on Tuesday, January 11, 2022 - 07:32 pm: |
|
David,
In addition to search by dimensions also select rotary shaft seals from the drop down menu.
I plugged in some numbers so you can see the results.
Then click search.
Ernie
Screen caps below.
It defaults to inch so if you are using a metric measurerizer then click millimetres.
Or if you want both click Display all measurements.
It is a very helpful page and I use it a lot.
 |
|
|
|
|
