| Author |
Message |
    
Robert Reinhart
New member
Username: reinhart
Post Number: 2
Registered: 01-2021
| | Posted on Thursday, January 07, 2021 - 07:30 pm: | 
|
I just acquired a barn find motor sn:45769. Two cylinder and in maybe runnable condition. It is missing one ignitor assembly, anything out there for a parts source?
I am new to the site, Thanks. |
miro forest
Senior Member
Username: miro
Post Number: 1113
Registered: 11-2001
| | Posted on Saturday, January 09, 2021 - 09:48 am: |
|
There are quite few Acadia engines in working conditions. You might have to be a bit patient , but you will be able to get help for sure.
Ignitor bits and pieces are not too hard to make up if you cannot find old parts.
I expect that ignitor parts from stationary version of those engine will likely fit OK |
Robert Reinhart
New member
Username: reinhart
Post Number: 3
Registered: 01-2021
| | Posted on Monday, January 11, 2021 - 03:53 pm: |
|
upon further knowledge of what I am looking at, I see the timing mechanism is also missing. Hoping to find these pieces in the garage it was stored in. Are the ignitors unique to the engine manufacturer or were they outsourced? |
Ernie
Senior Member
Username: ernie
Post Number: 2622
Registered: 01-2002
| | Posted on Monday, January 11, 2021 - 05:54 pm: |
|
Robert,
Do you need the front or the back ignitor? They are mirror image of each other.
Ernie |
Robert Reinhart
Member
Username: reinhart
Post Number: 4
Registered: 01-2021
| | Posted on Friday, February 19, 2021 - 03:34 pm: |
|
I need parts for the flywheel end, thanks. |
Dave Trickett
Member
Username: dwandi
Post Number: 9
Registered: 04-2014
| | Posted on Thursday, March 11, 2021 - 07:55 pm: |
|
Robert, I have sent you an email, I am confident that I should have what you need for the engine. |
L Boehl
New member
Username: queeniebee
Post Number: 1
Registered: 05-2021
| | Posted on Thursday, May 13, 2021 - 08:02 am: |
|
I am new to this discussion board.
Question about mounting a 1930 Palmer YT-1 in a Chesapeake Bay Crab Skiff. Can anyone tell me what Palmer recommends for the maximum mounting angle of the engine? The mounting is currently 15 degrees. Is this too acute? The answer is most likely in Dick Day�s YT-1 Manual, I had a copy and cannot locate the manual.
Thank you for any information you can supply. |
