|
| Author |
Message |
    
miro
Senior Member
Username: miro
Post Number: 1084
Registered: 11-2001
| | Posted on Saturday, June 20, 2020 - 08:17 pm: | 
|
OK, got the pictures of the flywheel. There is about 1 finger's space between the hull and the flywheel.
Last yeat that caused some issues, when I was navigating 3-4 ft swells in a cross wind. My boat, as they say , is "wet" . So quite a bit of water splashed in , in fact enough that it started spraying water about 5-6 ft into the air.
eventually, that shorted out one of the plugs, but I got there on 1 cylinder.
The stern squats a fair amount so a regular bilge pump won't work, - not enough space. I got a diaphram pump to such out the bilge water - problem solved. And yes, I have a hand powered bilge pump too.
Miro
You can see the flywheel is really close to the hull
From another angle
Here is a shot of the stern area. It really closes in . You can see the positive displacement diaphram pump that I installed. Murphy's Law says, I'll never will have to use it now.
 |
narrabay2
Senior Member
Username: narrabay2
Post Number: 78
Registered: 10-2019
| | Posted on Saturday, June 20, 2020 - 08:39 pm: |
|
looks great miro. I would put a wooden cover on the pump, make it look old. what a sweet setup and yes it is tight.
what about also a rubber wiper against the up-side of the flywheel wrapping around a little bit? well the pump should take care of this anyway.
I like the copper stern grease tube |
chris_spring
Senior Member
Username: chris_spring
Post Number: 53
Registered: 02-2019
| | Posted on Sunday, June 21, 2020 - 04:24 pm: |
|
The Adams install in the Gidley
Cheers!
 |
|
|
|
|
