| Author |
Message |
    
mike_w
New member
Username: mike_w
Post Number: 1
Registered: 10-2005
| | Posted on Sunday, October 02, 2005 - 06:20 pm: | 
|
Hello I have a 1 cylinder engine approx. 20 inchs tall.It has a one peice cylinder with non removeable head. Flywheel is approx 12 inchs in dia. 3 inchs wide. Stamping on brass cover on timer Ferro Machine and Foundry Co. Cleveland O. Brass water pump ecentric driven off crank shaft. brass carb. don't see any name on it. Carb & exhaust manifold looks to be held on by 1 stud between them cast peice slides over stud & held on by a nut & puts pressure on both manifolds to hold in place. One cooling water connection is on exhaust manifold. Would like to know Hp. year & any info on this engine. Thanks Mike |
bruce
Senior Member
Username: bruce
Post Number: 279
Registered: 07-2002
| | Posted on Sunday, October 02, 2005 - 07:08 pm: |
|
Mike, Pictures posted with your inquiry are almost essential for exact identification. looking for your next post. |
billschaller
Senior Member
Username: billschaller
Post Number: 149
Registered: 12-2003
| | Posted on Monday, October 03, 2005 - 08:56 am: |
|
most ferro's I have seen have a removable head. Need a photo |
Walter Prichard
New member
Username: mr_saxon
Post Number: 1
Registered: 11-2005
| | Posted on Tuesday, November 22, 2005 - 07:43 pm: |
|
I am looking for the picure of the Ferro engine located in a ghost town in Washington. I am also looking for information on a small 90 cu, in. 4cyl engine manafactured by Ferro. |
Mike Wade
New member
Username: mike_w
Post Number: 2
Registered: 10-2005
| | Posted on Tuesday, April 25, 2006 - 06:32 pm: |
|
Hello it has been some time since my last post! finally a picture of the Ferro engine! Thanks for any help identifying.
 |
Jim Parrott
Senior Member
Username: jim_parrott
Post Number: 212
Registered: 06-2009
| | Posted on Thursday, August 29, 2019 - 12:12 pm: |
|
Mike,
Last week we spoke in Portland about an exhaust manifold for your Giles/CT Wright engine. The Detroit�s look similar but the bolt patterns are way off and would not fit. Thought I had your e-mail address but it�s gone, hope this message finds you.
Jim |
