| Author |
Message |
    
robbert
New member
Username: robbert
Post Number: 2
Registered: 01-2005
| | Posted on Tuesday, April 26, 2005 - 05:21 am: | 
|
hello,
I am saerching for parts for a volvo penta md1, i just can�t find them. now i was asking to myself if it�s possible to place a diferent engine in the same place. are there any sugestions on engines with the same size. or is there anyony who dioes have parts for my volvo..
hoping for a reply.
robbert,
the Netherlands |
darelliano
New member
Username: darelliano
Post Number: 1
Registered: 01-2014
| | Posted on Thursday, January 02, 2014 - 09:23 pm: |
|
hi
does anyone have a replacemant for a early model volvo penta MD1 dynostarter (starter/generator?? I am out of options and could really use some help!! Or maybe a conversion kit if there is any such thing..
Thanks for any help |
eric
Member
Username: eric
Post Number: 29
Registered: 03-2006
| | Posted on Friday, June 27, 2014 - 08:22 am: |
|
Does anyone have piston rings for the MD1B? they are larger than the MD1 (about 3.1/2") The part number is 875498. I am also looking for shell bearings which are the same as the MD1 part number 875491. I am stripping two engines down to make one good one and really need these parts urgently. At Keyparts they are very expensive, you could buy four sets of rings for a quarter of the price if it were a car. Please help, Many thanks |
eric
Member
Username: eric
Post Number: 30
Registered: 03-2006
| | Posted on Friday, June 27, 2014 - 08:34 am: |
|
hi darelliano, they are quite hard to find but occasionally come up on ebay. If you get one be sure to match it up with the correct regulator. Don't buy them off ebay as they are too expensive, get a local auto electrician to get you a solid state one which will only cost about �30. they work great, I know, I have one on my boat, that is when I can get some rings to finish the overhaul of my engine.. regards Eric |
shindig
New member
Username: shindig
Post Number: 1
Registered: 09-2015
| | Posted on Saturday, September 26, 2015 - 01:36 am: |
|
I need piston rings for an old MD1, 3.1/4 inch piston. Does anyone know if rings for a car engine of this size would work? |
