|
| A Coule of engines - Evinrude and St ... |
| Author |
Message |
    
miro
| | Posted on Tuesday, July 22, 2003 - 02:15 pm: | 
|
From the same boat show where I saw the Liberty V12, here are a coujple of engines. The Evinrude is a bit mysterious it was bought about 20 years ago and was described as a canoe engine - but no water pump and no grease cups. It's a wee engine and might have been an outboard. Anyone care to offer opinions? ?
Miro
 |
Roger DiRuscio
| | Posted on Tuesday, July 22, 2003 - 02:36 pm: |
|
The cylinder on the Evinrude is off a rowboat motor outboard. I have most of a canoe motor.
mine has the water jacket in and out pipes on the same side. One is low and one on top. This engine has the side by side which would only work on a vertical installation. I have never seen this flywheel on a outboard motor. All this leads me to believe this is a assembled engine using what ever parts were at hand, I also have not seen this mixer on a Evinrude before. But of course I see new stuff every day. Any one else?????
Roger DiRuscio |
Ernie
| | Posted on Tuesday, July 22, 2003 - 03:12 pm: |
|
The crankcase sure looks outboardish. The way it is mounted appears to use the same bolts the transom clamp would have bolted to. |
Bill
| | Posted on Tuesday, July 22, 2003 - 06:45 pm: |
|
No waterpump, fabricated mounts and the mixer is on a manifold which if removed would rotate it 45 degrees. Outboard conversion! |
Paul Scheppe
| | Posted on Tuesday, June 29, 2004 - 04:32 pm: |
|
Looks like my 1920 evinrude a15632... http://f2.pg.photos.yahoo.com/ph/pscheppe/album?.tok=phdfHWBBeS0XLNCa&.dir=/9b92&.src=ph |
|
|
|
|
