| Author |
Message |
    
madmec03
New member
Username: madmec03
Post Number: 1
Registered: 06-2007
| | Posted on Monday, June 18, 2007 - 06:29 pm: | 
|
I have just bought an old boat with a Johnson/Evinrude 85 HP motor that needs some work. I need to know the year of this motor. The model # is 85ETLB775 The serial # is J4766638. Can any one help?
Thanks, Russell |
andrew
Moderator
Username: andrew
Post Number: 883
Registered: 11-2001
| | Posted on Monday, June 18, 2007 - 06:43 pm: |
|
Russell,
It is probably 85ETLR77S not 85ETLB775
That is a 1977. See this link for manuals.
Parts can be found here.
You can ask questions on the board at MarineEngine.com in the Johnson/Evinrude category. |
wgatormon
New member
Username: wgatormon
Post Number: 1
Registered: 06-2007
| | Posted on Monday, June 18, 2007 - 08:32 pm: |
|
I just obtained an old Evinrude outboard. It says on it whispering power aquasonis fleet twin 25.The only numbers I can find are as follows:7518-22380 no letters can anyone tell me the year and fuel mixture for this motor? Thanks Walter |
madmec03
New member
Username: madmec03
Post Number: 2
Registered: 06-2007
| | Posted on Monday, June 18, 2007 - 09:27 pm: |
|
Andrew,
Thank You it is 85ETLR77S It is worn a bit and couldn't see it well. Thanks for the help.
Russell |
fluvial
New member
Username: fluvial
Post Number: 1
Registered: 06-2007
| | Posted on Tuesday, June 19, 2007 - 08:57 am: |
|
I just purchased an Evinrude Jr outboard model # EJRCDR and serial # B018092 and would like to know more about it. What year was this motor made and what is the horsepower? I think it was made in 1986 but when I check that model year I cannot find this motor. |
Ben HartLenn
Visitor
| | Posted on Friday, July 20, 2007 - 01:51 pm: |
|
Can anyone tell me the fuel:oil ratio for a 1993 Johnson 9.9 Model# CJ10RLETR Serial# G 0299 4037 ?!?!? |
galpin
New member
Username: galpin
Post Number: 1
Registered: 07-2007
| | Posted on Tuesday, July 31, 2007 - 10:16 am: |
|
Does anyone have an instruction manual for a Evinrude EJRCDR Junior, 1986 1.2 hp? Specifically, I want to find out the best way of tweaking the air and fuel mixture dials and the throttle lever. You can send me a message at [email protected] and a scanned copy of the manual would also be great. |
empaynejr
Visitor
| | Posted on Wednesday, July 16, 2008 - 12:36 am: |
|
I have a 1979 Johnson 6HP, model# 6RL79E, that I use on a 22' sail boat.
I can get it to run just above idle, but when I open the throttle more it just stalls. Any suggestions? |
mike s.
Visitor
| | Posted on Monday, February 02, 2009 - 08:37 pm: |
|
i have johnson or evinrude motor ,twin ,light blue faded name i think it says johnson mod#OD-10 serial#822707 does anyone know hw to tell |
galpin
New member
Username: galpin
Post Number: 2
Registered: 07-2007
| | Posted on Monday, February 02, 2009 - 09:19 pm: |
|
Try this web site. It has manuals for lots of engines: Put Evinrude in the product box and go from there. 1986 1.2hp etc. Carburetor Crankshaft&Piston etc.etc.With each of the systems are the part number plus a diagram of the system. http://epc.brp.com/login.aspx?Return...ands=ej&lang=E |
JOHN SALVAGGIO
Visitor
| | Posted on Thursday, April 02, 2009 - 02:49 pm: |
|
I HAVE AN 1977 JOHNSON 85HP MODEL 85ETLR77S AND I WAS WONDERING IF THERE IS A SPOT TO PUT A PEE NOZZLE SO I KNOW IF THE WATER IS TRAVELING THOUGH THE MOTOR. ANY ADVICE WOULD HELP |
dshands
New member
Username: dshands
Post Number: 1
Registered: 05-2009
| | Posted on Friday, May 08, 2009 - 03:30 pm: |
|
I have a 1977 Johnson (Javlin) motor model # 85ETLR77S on my Thompson boat. The problem I have is that sometimes it starts and runs great. Then there are times that it rolls over, but will not fire up it is hit or miss if it'll start. I have a new battery on it. Any suggestions or help would be appreciated. |
solarrog
Senior Member
Username: solarrog
Post Number: 356
Registered: 03-2002
| | Posted on Friday, May 08, 2009 - 03:43 pm: |
|
Sounds like its time for an ignition tune up
generally fuel problems are not intermitant |
ernie
Senior Member
Username: ernie
Post Number: 972
Registered: 01-2002
| | Posted on Friday, May 08, 2009 - 05:16 pm: |
|
It should be new enough to have good ignition coils. However it is worth a look. Remove the tin cover in the middle of the flywheel and make sure the coils are not cracked. If they are it will be very obvious and they need to be replaced. If you need replacement coils they are available from www.marineengine.com
Hope this helps
Ernie |
jb_castagnos
Senior Member
Username: jb_castagnos
Post Number: 451
Registered: 07-2002
| | Posted on Friday, May 08, 2009 - 06:51 pm: |
|
I think this Javelin is a V4, if so it probably has 4 coils, I would look at the stator or module. The stator can be checked for a/c voltage, I don't know the values, but they were a problem area. |
dshands
New member
Username: dshands
Post Number: 2
Registered: 05-2009
| | Posted on Saturday, May 09, 2009 - 05:04 pm: |
|
I'd like to say thankyou to all that replied so quickly to my post. It sounds like my problem will be relatively easy to check and fix. I will check those items soon. It sounds like I'll be boating in no time at all. |
Bette
Visitor
| | Posted on Saturday, June 06, 2009 - 12:09 pm: |
|
I just purchased an Evinrude Junior on Ebay - Belgium #B0106869 - JRCDR. Have not received it yet but it was advertised to "run great" and will be used with a fiberglas rowing boat. What should I know about this motor - year of mfg? reputation for reliability, maintenace schedule, etc? Many thanks. |
dshands
New member
Username: dshands
Post Number: 3
Registered: 05-2009
| | Posted on Saturday, July 11, 2009 - 05:52 pm: |
|
I have a 1977 Johnson outboard motor model # 85ETLR77S on my Thompson boat. The problem I have is that when I put the boat in reverse, it's like it dosen't catch. Eventually it does go into gear, but not after it makes a noise like something is missing. I have no issues with the forward gear. I've been told that my linkage needs to be adjusted. Two years ago I had new throttle cables installed. How hard is it to properly adjust the linkage if this is the problem. This problem just started. |
joshkuchinka
Visitor
| | Posted on Thursday, October 29, 2009 - 09:11 am: |
|
I replaced my inpeller on my 73 25 hp evinrude. Put it all back together, and no forward. only reverse and neutral. I messed with the linkage through the access on the side of the motor, but nothing what should I do next?? |
james t halcrow
Visitor
| | Posted on Saturday, March 19, 2011 - 07:21 am: |
|
dont know year or model number of my 5.1 johnson outboard motor. searial number is 1213112. got this number from freeze plug.can tou help? |
Lisa Forbes
Visitor
| | Posted on Saturday, July 30, 2011 - 06:36 pm: |
|
We have a 1992 Evinrude 115 outboard motor. Sometimes it runs great then it will just start sputting and looses power. It idles fine all the time. We have new spark plugs, new hoses, new carborator kits. We are frustrated. Can anyone offer some suggestions? |
solarrog
Senior Member
Username: solarrog
Post Number: 490
Registered: 03-2002
| | Posted on Saturday, July 30, 2011 - 06:50 pm: |
|
HAVE YOU CHANGED THE WATER PUMP IMPELLER?
they will do things like this when they get hot. I will leave all the tuning advise to others
Roger |
ericwillis
Visitor
| | Posted on Friday, November 04, 2011 - 05:39 pm: |
|
i have a 79 100 hp johnson in good running order whats it worth |
terry hawkes
Visitor
| | Posted on Saturday, November 24, 2012 - 06:35 am: |
|
hi i have a 1980 85hp johnsons out board it wont start it turns over and has good compresion if i spray some easy start in the carbs it revs and stops but thats all i can get any ideas thanks teryy |
Corey DeMerchant
Visitor
| | Posted on Wednesday, September 18, 2013 - 11:27 pm: |
|
i have a 1977 johnson 85 hp v4 how do you get the dam prop shaft out? i got the bearing carreer out and the 2 c clips out but cant remove prop shaft...do i have to drop the foot and remove the shift link? is the shift link holding the prop shaft? can someone reply to my email plz its [email protected] |
aaronwatkins
Visitor
| | Posted on Tuesday, September 24, 2013 - 08:02 pm: |
|
I have a 79 Johnson javelin 85hp. I have a hard time stating it an it staying running. but when it finally starts an runs for about 30 mins it has no prob starting or running after that it can sit for hours an it will fire right up an run with no prob. just when I first go to launch or days later like when the motor is cold I have a hard time starting an keeping it running any suggestions. |
solarrog
Senior Member
Username: solarrog
Post Number: 558
Registered: 03-2002
| | Posted on Tuesday, September 24, 2013 - 08:26 pm: |
|
Sounds like the fuel pump is up to par |
solarrog
Senior Member
Username: solarrog
Post Number: 559
Registered: 03-2002
| | Posted on Tuesday, September 24, 2013 - 08:34 pm: |
|
**** Not up to par
oops |
jason_12
New member
Username: jason_12
Post Number: 1
Registered: 10-2013
| | Posted on Wednesday, October 09, 2013 - 08:09 am: |
|
I have a 6 hp evinrude don't know the year but the model number is 6702s-E14484 and I broke the rip cord on it and don't know how to put a new one on please help urgent !!! |
warrin b
Visitor
| | Posted on Sunday, May 04, 2014 - 08:38 pm: |
|
I have a 1976 by before Johnson 85 horsepower it idles great but when I go to put it in drive it goes dead like it doesn't want to get gas any suggestions? |
Ryanbrettingham
Visitor
| | Posted on Monday, May 26, 2014 - 06:11 pm: |
|
I have a 85 evinrude when I take it out on the water it'll take a good 5 mins to get it to start. It'll roll over but don't fire right off the bat. The way I get it started is to keep messing with the choke and the fuel bulb an when it fires and start ill hurry and push the throttle down. After that i can fire it right up but if i let it set for about 45 mins i have to do the same thing over again. I just change the spark plugs didnt help. Does anyone have any idea what could be my problem? |
Dannypal
Visitor
| | Posted on Sunday, September 14, 2014 - 01:46 am: |
|
Hi I just bought a half cab with an 85hp johnson v4 and wondering what year engine is on it, all the post I've read kind of state that its a 79 mod but looking at what the engine has seems newer for eg it has 4 carbys, individual coil packs, can anyone tell me more info, also the oil/fuel ratio it should be running
Codes 85ti79r A643967
Thanks |
rboxcar
New member
Username: rboxcar
Post Number: 2
Registered: 03-2015
| | Posted on Thursday, March 26, 2015 - 07:03 pm: |
|
I have a Evinrude Motor Model Number 18502S-E03403 Could anyone tell me the Year and Horsepower. Maybe what it would be worth to sell |
ernie
Senior Member
Username: ernie
Post Number: 2030
Registered: 01-2002
| | Posted on Friday, March 27, 2015 - 07:20 am: |
|
Mostly inboard engines here
Try aomci.org |
Greg.wiggi
Visitor
| | Posted on Sunday, August 07, 2016 - 08:52 am: |
|
I just bought a 1977 85hp outboard. I can not tell what model or make it is. It is either Evinrude or Johnson but not sure which. No I'd plate. Where would I find the serial number? |
