|
| Wanted Intern'l Palmer engine head |
| Author |
Message |
    
tamster013
New member
Username: tamster013
Post Number: 1
Registered: 07-2005
| | Posted on Sunday, July 10, 2005 - 10:28 am: | 
|
Trying to locate where I can get a Palmer engine head, 345/392 motor. Fresh water cooling. Boat located in Virginia. |
ernie
Senior Member
Username: ernie
Post Number: 517
Registered: 01-2002
| | Posted on Sunday, July 10, 2005 - 03:34 pm: |
|
Give any older junkyard a call. Most of the international school busses in the 70's used the 345 and or the 392 IH engines. If you go this route I would suggest changeing both heads to make sure you have the same compression ratio on both halves of the engine. Or at the least check casting numbers and give a good visual inspection for comb chamber shape and size. Also look at valve size, springs, rotaters etc.
Hope this helps
Ernie |
robert jorgenson
Visitor
| | Posted on Tuesday, October 04, 2011 - 12:22 am: |
|
head for Palmer P60
exhaust manifold p80
bob 435 678 3436 |
Eddie Ross
Senior Member
Username: eddie
Post Number: 274
Registered: 04-2003
| | Posted on Tuesday, October 04, 2011 - 03:27 am: |
|
You can get aftermarket heads for the tractor version of the P-60. You will have to drill and tap a 1/8" pipe thread hole on the top, forward end for the air bleed line fitting to convert it to marine use |
|
|
|
|
